Futuro Futuro IS36TACTIO Manual

Busca en linea o descarga Manual para No Futuro Futuro IS36TACTIO. Futuro Futuro IS36TACTIO Tactio Range Hood Installation Manual [sv] Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 2
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
11 13/16”
11 5/8”
11 5/8”
Futuro Futuro
Futuro Futuro
RANGE HOOD
INSTALLATION MANUAL
MODEL: TACTIO ISLAND
NOTE: PRIOR TO INSTALLATION
Please inspect range hood visually,
as well as connect it to power supply
and test its operation.
RECOMMENDED
INSTALLATION HEIGHT
1
26” - 28”
from cooktop
to bottom
of hood
Height “X”
Ceiling height
- 36” countertop
- 26”-28” spacing
- 14 1/8” hood
14 1/8”
Recommended
Installation Height
1
Recommended
Positioning
2
INSTALL CEILING PLATE
1.) Locate the centerline of the cooktop/range, and project it upward onto the ceiling.
2.) Place the ceiling plate against the ceiling, centered over the cooktop/range, and mark location of holes.
NOTE: 24” model has square plate with 4 holes, 36” model has rectangular plate with 6 holes.
3.) Drill holes as necessary.
4.) Secure ceiling plate to ceiling with screws (concrete/masonry ceilings: with anchors + screws).
3
ATTACH SUPPORT WIRES
1.) Loop the supporting wire through the lock-nut, as shown.
2.) Secure screw through the lock-nut (with the wire in it) into the ceiling, inside the inner cut-out of the ceiling plate.
3.) Repeat Steps 1 & 2 for the other 3 wires.
4.) Thread support wires through the 4 horizontal holes of the ceiling plate, as shown.
NOTE: There are also vertical holes on the ceiling plate anges - those are for mounting the trim cover, not for support wires.
4
Range hood should be
centered over the
cooktop / range
Center of
cooking area
Vista de pagina 0
1 2

Indice de contenidos

Pagina 1 - Futuro Futuro

11 13/16”11 5/8”11 5/8”Futuro FuturoFuturo FuturoRANGE HOODINSTALLATION MANUALMODEL: TACTIO ISLANDNOTE: PRIOR TO INSTALLATIONPlease inspect range hood

Pagina 2 - SECURE TRIM PLATE

SITUATE THE TRIM PLATE1.) Thread the support wires through the trim plate.2.) Raise trim plate to the ceiling & temporarily secure it with 1-2 scr

Comentarios a estos manuales

Sin comentarios